|
i know the set, person not know how it so good but now the crt is ok so i want check the if and see if the hv is messing up the wiggly convergence sides and know that person that had it would not want to let it not converge unless the flyback is bad and the solid state means tubes are ok but not needed and the hv will be ok as long as the if is aligned with the regulator so i want to get it to recap and check all the resistors also because I have been told they effect the flyback circuit since its all enter relatated and so you need to check the coils for leakage and other stuff that the transistors are not shorted but can be if the diodes are open or closed and so the shorts in the tubes on the crt are always a good place to start afte checking the disk caps formica like used in the kitchen floor but that builds up static that cans zap and diode and make it closed before checking so you need to not step on the rubber mat on the kitchen lastly but before and make sure you use a ungrounded soldering iron on the wires next to the transistors or get new tran sistors from moyers first becasue the can short and ruin the alignments done on the hv regulator currrent resistor bridge that is use for the focus and can make the crt glow if not grounded to the shorts but before doing that the grids should be cleand to not overload the yoke drive to the horz hold pot unless thats not tested last.
|