|
Zenith 6D2614
I recently purchased a Zenith table radio, model 6D2614, chassis 5B01/6B01. This was my first successful electronic restoration, and now I have just a few questions. It appears that it is not a hot chassis radio, because the line cord is not directly connected to the chassis like some of the other radios I have. Can anyone verify this? Also just a general question- I have read that to test the audio section of a radio, you can connect an audio source to the volume controls wiper. Is this applicable to any radio? Where should the sources ground be connected? I will post the schematic when I find it and pictures if needed.
|