|
boost filter cap on sweep board (between boost and B+ feed vert osc plate thru a pot) was a bit weak (would not open the eye all the way) leakage test was ok. Replaced it. A .0068 couples the feed back to the grid of the vert osc was very weak would barely open the eye, leakage test ok, replaced it.
A 82k resistor in the feed back loop had drifted to 120k, I think this one may account for the osc speed being off as it looks like its part of the RC networks that establishes the osc rate. there is one more in there that I need to check, its the .0082 right off the plate of the mutivibrator, I suspect it gets a lot of abuse in the form of some pretty high spikes. After that I will reinstall and see if the pairing has improved. All the ground stakes looks good.
|