Drat, I replaced a few electrolytics, one resistor and two Bumblebee Caps, put it back in the cabinet, brushed against the 1B3 cap, recoiled and ripped the base cap off the CRT.
It was broken and loose to start with and all the wires but one just came out but one broke off flush with the glass. (sigh)
A couple wires ripped out of the connector as well but I fixed that easily enough, oh yeah, and my soldering Iron came in contact with the fine tuning knob I had stuck in the back of the cabinet so now it has a melt mark on it, some days it's better not to try and fix things.
I was able to scrape away enough glass on the CRT base to make a connection, it's very poor but it works, I trimmed away the rest of the broken Cap so I can see it and resolder it if needed.
Anyway, the set works fairly well now, it's a bit unstable, especially cold, no doubt a full recap would make it 100% but I don't want to do that unless I find a good CRT at some point.
It's sitting her playing as I type this, the vertical loses sync now and again, the sound is terrific!