|
green and blue drive fully CW
Red,Green,Blue screen fully CCW
Bias Switch fully up
service mode
I don't recall if the brightness setting has to be set to a start point.
turn up one screen at a time until you just see the line, then back off until it just disappears. do this for all three screens.
if any one color can not be displayed start over but move the bias switch down one postion (its a 3 pos switch) try again on the weak color, if you still cant get a line then move bias down one more.
All that being said I would not worry about the setup untill you get the vertical working.
|