Quote:
Originally Posted by Electronic M
The screen looks bright enough to me.... As for the lousy contrast: have you tried adjusting the AGC control(usually located on the back of most sets)? If AGC has a positive effect then center the contrast control and adjust contrast to be good at that point and then rotate the contrast to check if it will go higher without overloading synch if so then your good. If not then back the AGC down until the the synch is stable.
|
my camera made it look much brighter than it actually was. All the lights were off, and I even had to put a blanket over the blinds on my window to get it dark enough for me to see it.
As for the AGC control, there is not one labeled as such anywhere on the set, there is however a Noise Gate and DX Range Finder control, both of which I have tried with no success.