I have this seriously oddball Sony PVM monitor, that was used as a movie prop. It was used in a few movies, including the TV series X-Files (a few X-Files episodes actually, not just one). It's a PVM-1390.
Sadly it has been beaten up a little bit by the time I got it, looks like Holywood never cared for it and got it very scuffed up, and the buttons on it have yellowed..
Pics of it when used in X-Files episode Conduit:
http://ladymanson.com/galleries/tv/T..._display_media
http://ladymanson.com/galleries/tv/T..._display_media
And here's that monitor today:
http://img.photobucket.com/albums/v3...agon/pvm-1.jpg
http://img.photobucket.com/albums/v3...ragon/moni.jpg
http://img.photobucket.com/albums/v3...on/showmon.jpg
http://img.photobucket.com/albums/v3...on/moniuse.jpg
It even makes a good RGB monitor via the computer input on the 25 pin connector:
http://img.photobucket.com/albums/v3...gon/genpvm.jpg
But, if you look closely in the shot from the X-Files, it had a slight pin cushion/trapezoid problem back then.. Very small but is noticeable. Well, even to this day, that problem is still on it:
http://img.photobucket.com/albums/v3...agon/dtv-1.jpg
Is this fixable? Considering it has the same problem as it did all the way back on Season 1 of the X-Files, I'm guessing just an alignment problem.
This picture, when on an SNES, shows just how bad the pincushion problem really is.
http://img.photobucket.com/albums/v3...agon/snes2.jpg
Notice the top edges and all along the sides of the picture.