|
Lets talk REMOTE...control that is
This set has a CPT10-A reciever and the handheld does not match the Sams schematic. The diagram shows a different component layout and has trimmer-caps to tweak each function.
The handheld I have has only one adjustment and the measured freqs dont match up even close to several functions. Some do. The only ID on the inside on the PCB indicates E-143365-1 RCA-5.
The only trimmer was soldered so it was replaced. The channel freq is right on and I'm back to the original issue. I get the idea this is not the remote for this chassis or I'm going to have to play capacitor roulette for each function.
Is this the wrong one? Is there a practical solution.
Last edited by 6GH8cowboy; 09-18-2012 at 08:49 AM.
Reason: added picture of remote
|