|
a ha!
while checking the convergence coils out (all good) at the male convergence pins, I next check started to check the female pin on the chassis, 1st up was the ground... hmm no ground to chassis, pull the chassis back a bit, got the flashlight out, whats this the ground buss is clipped! no ground for the convergence coils, well gee no wonder they did not seem to be working (at least the dynamic) Not sure why that would have been clipped, I know I would not of done it since it was just a ground to a connector that would have been unplugged so no need to clip it out. Taking a break know but hope to report back soon...
|