Quote:
Originally Posted by wa2ise
DO be careful, as there are high voltage pulses on bare solder terminals on the yoke. With the set off, loosen the strap that holds the yoke on the CRT neck, and gently push it toward the front of the set sliding it on the neck. And try to tilt the yoke in the direction and angle so as to cancel the tilt in the video image. tighten loosely the strap, and turn the set on to see how well you got it corrected. It may take a few iterations to get it correct. Once you got it good, finger tighten the yoke strap. Not tighter than that, as it is a glass tube it's squeezing.
|
Thanks for the details. Is the Yoke the white ring in the photo below? Sorry to be such a noob.
