|
I've hacksawed off old can electrolytics near the base, the location just above the fat part at the base. That fat part holds a rubber gasket, which holds the terminals down below the chassis, and has wires passing thru to go to the actual cap guts. Clean off the top of this rubber gasket, and then either mount new caps to the terminals below the chassis, or drill small holes to pass new cap leads so you can mount the new caps topside and have the leads connect to the appropriate terminals below. If you're lucky you can slip the empty can over the new caps on the topside. Put one or more caps down below if they don't all fit. One advantage is that you don't have to undo the wiring on the terminals.
__________________
|