|
Where shoud I begin?
I've had this nice little Trinitron for a few years now, and it did work perfectly, until it blew its internal fuse. Replacing it had the same thing happen.
If it was tubes, I'd know where to begin - a re-capping would probably cure the problem, but my experience with solid state is virtually zilch. Close inspection in the back doesn't reveal any obvious problems.
Without a circuit diagram, I could still replace the big caps - would this be the way to go? All advice appreciated.
PS the analog TV signal is being switched off in South Australia in early April, and if I can get this one going I'd be using a set-top box and modulator to keep it current.
Cheers from summery SA.
|