|
It's a mystery for sure. When I went through replacing the caps in the set there was a wiring error in this part of the set. C173 and C169 were reversed. What I hadn't noticed was this red tubular cap was also wired in C169's place. So in essence there were two capacitors in C169's position, I replaced the one I could see (and put them in the correct place) and didn't notice this one hiding until later. The junction of T108A, C172, C173, and C169 was hacked up pretty bad from a previous repair job, lots of leads just clipped off and left in the set waiting to short something else out. There was also a bumble bee cap hiding in that junction (mistake these for resistors sometimes) that tripped me up for a little while.
All part of the fun.
Can't wait to get this one finished and posted up in the B&W section.
|