|
Hi All;
Bob, take out the little can first, take off all the wires and then straighten out the Twist tabs.. Then do the same to the longer one.. Then take the two screws off of the side of the Bracket, that should give you just enough movering room to Back out the longer cap.. If not, You might have to loosten the Screws and nuts a little on the transformer, to get the last quarter inch of room.. Them moving the Bracket out away from the back of the set, you should be able to slide out the cap.. Make sure before taking either cap out the you can wiggle them out some, and that the twist tabs are not still holding the cap in place..
THANK YOU marty
|