|
3 more things, I had replaced a power resistor (4.7k that was about 8.5k) and had failed to solder it (but it was neatly thru the term stip hole and wrapped completely around, it was part of the color osc circuit IIRC), 2 I noticed that one of the demodulator plate load resistors had been replaced in the past (poorly I might add), it was a 6.8k. I noticed the other demodulator plate load resistor was a 5.6k, I double checked the schematic and it was a 5.6k there as well. IF it had been a better installation I would have maybe chalked it up to a factory mod, but since it was poorly j hooked in I will replace it with the correct part (this is from a factory service manual not a sams). 3 I replaced the .15 cap that is connected across the eff coil. it tested very leaky but still was able to open the eye tube about 1/2 way when checking for value, but it was about .25 uf tested vs .15 marked. The initial test run I did not attempt to set the dip of that coil since it was inside the HV cage and I had no access to it. Now with that cap replaced (the 2 .1s on either side of it test like new) I will attempt another start up. this time with the set on its side so I can get easy access to that coil.
|