|
what you see is a test jig, the set had a dead CYP (red filament out) but I have a 21FBP to replace it with.
I will do a quick test on the effect of the board soon. Right now I am running it with a jig plug in the convergence socket (no load, just a 150 resistor), I also have the correct convergence board, its just not installed anywhere.
So the plan is to leave the digital meter hooked up, and do a test run with the board plugged in and then a quick comparison with just the 150 ohm jig plug. should be interesting. IF there is a difference (which I presume there must be) then of course the next logical thing to do would be to recap the convergence board (assuming the caps are all bad which is likely), and do another run.
I have other roundie convergence boards that are newer and have better caps. I assume they are wired the same (at least the ones with the octal plugs). would be nice to just try one and see as well (effect on current).
|