Quote:
Originally Posted by holmesuser01
One of the issues with the IC601 dying was the horizontal width would suddenly get very small. If it stayed that way very long, parts started dying.
|
Yes if you get it going you cant run it with that width problem.
If you get there look for connections I mentioned & D502,3 & 4
something from the hoz drive through FBT or in the pin or yoke ckts.
Beyond the obvious its to deep to troubleshoot on the internet.
Same with the PS. Things are getting deep.
Dont forget when making measurements anything around IC601
and on that side of the 2 transformers use neg end of C606 for
ground. For the rest of the set use the cold ground pins 3-4
of the connector, or any good chassis ground when you get there.
Good luck Zeno