[Electronic M]

Well after replacing most of the resistors in the horizontal section and fixing a bad PCB trace, I was able to get the HOT to stop redplating and get between 10-15KV on the HV lead(with the yoke unplugged).
At which point I figured it was a good time to put the chassis back in the cabinet for a test power up. At first there was no noticeable light(with the florescent lights on), but there was 20+KV of HV so I tried some knobs.

The result shown below.



There is now sound and raster, but no hint of video so more troubleshooting still lays on the horizon.

I'm feeling a lot more confident now, that I will make this set usable again.

I'm probably going to pause work on this set here for a while so I can fix a vertical problem on my Zenith roundy.

MORE Bananas!!!!