[TinCanAlley]

Have a question about the usage of this tester. I've gone over the manual and check their site, but can't figure out exactly what they mean when adjusting the individual G2 controls. I've a attached a pic to show the unit (the flash washed out some of the control markings).

In second to last testing setup it says to adjust each G2 control until it moves up "one division" on the scales. I'm assuming that one division is a vertical mark on the face, but which scale should be used? Is a division one of the taller and wider apart lines or is one of the shorter and closer together lines considered a division? In the upper left of the meter face is says to add one division for setting cutoff, but that's just a vague as the manual.

Thanks!