[Username1]

Thats right, you can watch it as is, you don't need to get it perfect.

Centering the adjustments just pick a center, middle of the range, thats it.

But I have been there, adjust all day and you end up with that one side that is so far off and the controls are at their max and you still have not got it. Its basically because the coarse adjustments were not close enough before you started turning stuff on the board.

You just have to set them so you have a range to play with and begin again. Its good practice, its not like you gotta get it done to get paid or anything, take yer time and enjoy it. I love doing convergence now.... Wait till you do it on a inline tube with only the ring magnets around the neck of the tube.... Much different animal there....

**....Sorry, I did not notice that you had made all these other threads for each step you have taken with this set.....**