Quote:
Originally Posted by TinCanAlley
Okay, hang in here with me. I just want to make sure this is as simple as I believe it is. I will take a clip-on lead from the ground point of the canister and then a clip-on lead from one of the 400uf legs of the canister. I will then take the other ends of the leads and clip them to a good cap and turn the set on. Is this correct? Also, if I'm reading the schematics correctly, the second 400uf cap is on the other side of the 16ohm filter that the first 400uf connects to. Should I do parallel both at the same time?
|
Negative to ground + to the can section. OK ?
The 16 ohm is a choke, common arangement called a pi filter.
Do one cap at a time. Sometimes subbing either side will
improve it, the bad part is the one that shows most improvement.
73 Zeno
