|
I think I'm going to do the following.
Put shrink tubing on the negative leads (about 1/2" of tubing)
Twist bare negative leads into a single lead and solder
Shrink tube negative lead leaving enough exposed to solder to a ground point
Shrink tube positive leads leaving 1/2" of lead exposed of each
Remove the wire leads from the canister and slide 2" of shrink tubing over each lead (not shrinking yet)
Solder wire leads to cap leads
Slide shrink tubing previously put on wire over solder joint and shrink tubing
Insert a board standoff in empty hole near to canister
Wire tie cap bundle to standoff
Of course this might not go exactly as noted, but it seems like a logical approach and should be safe and tidy. The shrink tubing should cover leads from body of cap and all soldered connections. There shouldn't be any exposed metal to short.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|