[cwmoser]

Do not recall any wholesale replacement of resistors for this chassis.

What I did was spend a couple hours doing a wholsale Resistor check.
I measured the Resistance of every resistor while still soldered in place.
Then made a judgement call as to whether the Resistor was reasonable.
Often other Resistors impact the read value.
But, if the read resistance is much over, I know the resistor needs replacing.
Most folks want the tolerance withing 20%.

If the read resistance is way too low, I look at the Schematic. Sometimes the
reason for the low resistance is another resistor or caused by a shorted capacitor.

When I did my Resistor Check, I had my little helper helping me:-)