Quote:
Originally Posted by DaveWM
If you can get a decently bright raster, I doubt the CRT is at fault. But you should learn how to use the tester to if you think you got it figured out, by all means check it. those Zenith CRTs of the era were quite good (long lasting).
you should not have to turn up the screen drives very far to get a bright raster (no signal just snow). If you turn them up and get a normal white brightness raster, then switch to service mode and DO NOT see the horz lines (RGB they will be faint but should be there, close together if not on top of each other), then there is something wrong that should be corrected before the jail bars.
|
If I crank up the G2s, I get a very bright raster. Switching the setup takes away the raster and all I see is a very faint blue line. If I turn down the blue, there are no lines at all.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|