Quote:
Originally Posted by Username1
Other than that, there are two attached pictures from a tv I own, its not yours, but it shows parts near the horiz. area that can be culprits of your problem. Suspect any parts near the red dots, resistors, caps, inductors. You should go to the Sams website and buy your tv schematic, look around in the same parts of the tv, Horiz Osc, Driver, and output stages. There are two red arrows on one of the pictures, they point to waveforms that are capable of generating the "ring" because they are a pulse, and are squared. If a part that is designed to filter out overshoot in the pulse rise is bad, then the circuit, or following stage will momentarily oscillate at a higher frequency and give you that ring, and go into another part of the tv and give you those vertical bars...... Do not overlook shielding, of any parts, picture tube, or grounds.
|
The H Osc, H Driver, H AFC and wave shaper are all located on a single module. I purchased an NOS module and swapped it out, but the problem remained. Should I check the grounding of this board?
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|