Quote:
Originally Posted by DaveWM
Andy is telling you how to use it like a voltage divider, on side of the pot is low the other side is the high the wiper (lead to crt) moves from low to high.
|
I'm trying to be the least destructive to the original setup of the circuit as possible. If I start cutting out resistors it will be hard to put it back to original condition.
I was under the impression that if I used terminal 1 from the Hi tap and terminal 2 to the CRT lead, it would act as a variable resistor? I'm must be missing something about how this circuit works.
What would happen if I connect terminal one to the Hi tap, terminal 3 to ground and terminal 2 to the lead to the CRT? Would that produce the effect I'm looking for, or would I short something out?
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|