Quote:
Originally Posted by zeno
If shorted they usually read real low ohms ( pin5 -pin 3 )
or 5-4 etc. the zeners on the output (pin 4 ) could do it also.
If one is gone I would change both. ECG is same as NTE &
maybe easier to find. Also could back cross it to an
origional number ( not GE ) but dont know where to do it.
Any markings on them ???
73 Zeno  |
There are 2 numbers on it 143530-1
underneath is 88419 and a logo of SGS.
I tested them and one did have resistance of .5 ohms between 5 and 4 and 11 M- ohms between 5 and 3 the other had of 11M-ohms reading on either points. I ordered a lot of 3 NTE1376 new unopened from eBay for $12.99. That was the cheapest I could find. While I have it out I'm going to check all the caps too.
Thanks for all the info I will update you when I get the parts in.
Jeff