|
Who makes your dmm, where did you get it, and how much$.
The pins at the horiz board, tp5 is 123, next one down is 124, and bottom is 6. The schematic you posted is not that clear, and gets worse when I blow it up, so If you check the voltages at each one of these points, are they correct, higher, lower?
You need to post "posted" value as in (sams) and actual, (what you read), How DMM Scope.
How about the wave form at the base of the HOT? is it good?
The diode, and cap in the collector circuit closest to the HOT on the schematic? they good?
Does the schematic detail the meter used ? for sams voltage readings?
__________________
Yes you can call me "Squirrel boy"
Last edited by Username1; 10-02-2013 at 04:29 PM.
|