|
Okay I finished the testing of the FB. I don't know how accurate it is as my leads seem to have .6 resistance of their own and I don't know if that should be disregarded or subtracted. I usually disregard it, but the numbers I'm looking at for the FB are pretty low and if .6 is added by the leads, it could easily triple some of the results. So if anyone knows what should be done in this situation, let me know.
I'm attaching the FB section of the schematic so you can see where/what I tested.
Below are the connections, the results w/out subtracting me leads and the values on the schematic. The first three are at the tie points on the board next to the FB. The rest were done at the chassis connections of the FB leads.
Connections Results Sams
3 - 9 / .8 / .1
4 - 8 / 2.2 / 1.6
9 - yoke plug / .12 / .5
G - R/W / .10 / .5
R/W - Blk / .8 / .7
Y - Blk / .7 / .1
Y - Vio / .8 / .2
I don't know if anything is thrown off by all the leads being connected to the chassis still. Nothing in the Sams says anything about tolerance, so I don't know how close or dead on they have to be.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Last edited by TinCanAlley; 10-02-2013 at 10:26 PM.
|