|
adj the HV will not do much to the flyback as it uses a shunt tube, and if working it just absorbs the excess current. there is an eff coil on the chroma board that should be adj for min current, this is all covered in the sams.
Leave the Se pack alone on the convergence, I have found that most of the time they are fine, you will know if the convergence does not work.
the 2 vs 1 in the focus circuit, the 2 was used in the later CTC-16 the 12's had a resistor in the filament circuit of the focus. If you see a resistor on the focus tube socket then it prob needs the correct tube the 1V2.
These sets often work just fine as found, I have several that have the orig filter caps. Sound like at least one may have already gone so I would at a min restuff that one. The film caps in the vertical circuit sometimes give trouble they are HV types 1600 IIRC. so if you have vert jumpiness or odd vert behavior then those should go. .0082 is the biggest offender as it takes the most punishment. Right off the plate of the vert out.
|