Quote:
Originally Posted by TUD1
Electronic M, is this drawing correct for imitating the Blu-Seal? For the sake of simplicity, I put down 50 and 80 mF.
|
Yup, that is exactly what I was describing.
Ultimately the exact filter capacitance is not all that critical in these sets. If the originals were both 20uF caps then likely the only differences in operation between the originals and what you have in it now (assuming the current lytics in it are good...which likely is not the case) is lower hum on the B+ line (higher filter capacitance usually=lower hum), and possibly slightly higher B+ voltage.