|
if you disconnect the delay line and jump it directly you get weak sync , no color , and its is jittery , I then tried a 2 ohm resistor and a 40 ohm resistor hooked to the delay line to see if the ghost and ice changed, it didn't , so my guess is the if section may need a tune up or maybe theres a cap or resistor in the yoke that's not right , or one of those capacitors that look like a resistor is at fault , I decided to give up and use it as is , its not unwatchable butit would be nice to have it a tad better , the cathode current on the horz out is 200ma , I had to turn the hv up all the way because if you don't the horz gets too skinny , focus is effected and circles are not circles , the anode is running 22kv and with brightness down around 22.5kv , the fly is not getting hot or warm, the convergence is very good , it does show some red around objects but that's with the color on , if you turn off the color they are gone so its not convergence , the red around objects will go away if you tune back but then the image is not as clear and you have to crank the color control high to get colors , again this suggests if tune up might benefit the set , can't complain about it because the colors are right and the image pretty sharp.
oh yeah I tried the stick idea and was careful, it made no change to the ghost , there is one that wont turn , its frozen , not sure which it is without looking at the schematic , just thought I'd add that
|