Tried a direct connection from coax to dipole leads, as well as increasing the coax feed length to 70+ feet, both to no avail.
Quote:
Originally Posted by zenith2134
On one of my B-T AM-60-550 units, I had a rolling bar which was antenna-dependent. upon installation of a proper coax run and dipole antenna, the issue went away 100 percent of the time. Prior to the antenna switch, I was using an F-connector-to-300 ohm balun and I figure that's what caused it.
|
Can you tell me exactly what antenna setup you have? Maybe there's something small that I'm overlooking.