[bigaudioal]

Am going to replace the candohm resistor pictured below in my Admiral Telebar set. Both portions test open. The values are 2725 Ohm @ 2.5 watt and 2650 Ohm @ 10 watt. I just received two ohmite wire wound resistors that should work fine. One 2700 ohm @ 3 watt and one 2500 ohm @ 10 watt. So, well within 10% on the values of both. Now, since I have not replaced a candohm before, take a look at the attached schematic and let me know if I have it correct. R92.

There are only 3 wires attached to the existing candohm. Two of those wires go to the socket plug for the radio/phono set at pins "M" and "N" The other wire goes to a terminal strip in the TV chassis.

I plan on joining the two new resistors together with the wire going to the "M" pin of the plug socket. Then the other end of the new 2700 ohm/3 W resistor to the "N" pin of the plug socket. Finally the other end of the 2500 ohm/10 W resistor to the wire going to the terminal strip in the TV chassis.

Do I have that right?

Thx!