Quote:
Originally Posted by rca2000
You must be a masochist...cause IF this is the set I think it is...you have a LOT of work left to do !!
If this set has most of the boards in a bunch of shields", then there are a number of capacitors that need replaced on THREE boards. The power supply...the "formatter" board and the "DM" board.
The other two boards are sandwiched together, on the right side of the shield box. There is a big connector that goes from the DMD board to the formatter board. you need to remove the shields around this and then seperate those two boards. There will be a number of 1000/16 or so capacitors on this board, near the top of it, IIRC. ALL of these need to be replaced. The same goes for the DM board behind it.
These sets are a BITCH to repair. we ALL hated to work on them in the mid-2000's , when they were still under warranty. A BIG reason was that..about 50% of the time... even when you replaced all of those caps--the set STILL did not work--or work for long.
If you have the time and patience--go for it. I no longer DO. I cut myself a lot of times on those damn shields !! I do not wish to do it any more.
|
Yep, this is THAT set.
Sourcing and replacing the caps is a cakewalk--the bitch of it is actually getting those damn boards apart and out of the set! I can't figure out how to separate and remove the boards from that metal 'mass' in the lower left of the rear of the set.