|
OK Brian, I will check my settings. Also, I need to find two cables for my scope. One would be BNC to BNC to run from my function generator to the scope. Another would be a BNC with alligator clip ends to apply signals from the generator to a circuit. Not that my lack of having these is the problem.
Just figured I would mention it because I was using an O scope probe to apply and/or measure signals from the generator until I found out that evidentally all scope probes are made with resistance wire. Someone on another page mentioned a need for the same thing as I and they thought that they could just cut the probe off and add some clips. Not quite that simple.....
__________________
"Face piles of trials with smiles, for it riles them to believe that you perceive the web they weave, and keep on thinking free"
|