[Username1]

A voltage source that is too high when others are normal means something using
that 130v is not working. With all circuits working the current draw will cause a voltage
drop across r29 so it all works out to 130v. Check those circuits not working, be sure
all the tubes are working, correct voltages all around. A tube turned off will not draw
its share of current, making a smaller voltage drop across r29.

Open load resistor, or tube in cutoff, possibly 2 problems. A single tube, or 2 section
tube not lighting up.... no current flow.... Be sure all wiring problems have been found.
double check, everyone overlooks things...

.