Quote:
Originally Posted by Username1
Remove plate cap, or be very careful and wear good insulating gloves.
If you absolutely have to run it with no picture tube attached, and I can't think of
any reason where that is the only option, I would attache the HV wire to a hv probe
like a voltage probe, and tape it off and put it inside a bicycle tube or similar rubber
protection boot. That way you have a load of some kind, you don't want that voltage spike
reflecting back onto the primary of the HVT.
.
.
|
Bicycle tubes are conductive. Well, at 10kV and up they're not good at insulating, under 250v they're fine. Just letting everyone know.
Concrete is conductive too!