|
great video and i found the cap and resistors as far as the disc i will have to change it because i have no way to positively check it and what is the voltage on that .01 disc cap? the resistors on the other hand well the 68k was found to be 69.8k and the 100k was found to be 100.8k both of which is well within range. so now if i can find out what the voltage rating is for the .01 disc ill change that just to be sure . the doubler caps being i have 4 in paralle 3 of which are the same brand but the 4th one is smaller and a different brand so i have 2 caps rated 450v 470uf i was going to put in place of what i have now and while it is a bit overkill at least they are both the same and there will only be 2 of them, just to rule out any possible problem with the ones in there now. im still debating weather or not i should leave the 2 caps in paralle that are .022 and .1 for the .12 that was in the set originally there are certain opinions about doing this with caps because one could go bad and pull down the circuit that its tied to so i would figure this could do away with any possible future problems since i dont have a cap tester on hand.
|