|
oh. BTW sometimes the SAMs resistance charts are just wrong. missing decimals or just wrong, and also sometimes they resistance numbers are influenced by pot settings. This should be noted but not always done.
Lastly they are only a guide. if something does not match up, its best to review the schematic and see if the measurements can determined by looking there. in your case the 14ohms does not make since prob should read 1.4 ohms. You can see this if you look at the schematic and trace the pins to the ground.
again if this is the area you are looking into, I would assume the set is not demodulating the color signal so you are getting BW only?
|