|
Thanks for the tips Tom and Eric.
I took off the back cover. Fortunately, no plastic was broken. I tried to align the edges, but could only get one half of the cover to get fully lodged underneath the covering. I was going to post back here asking what to do next, but then I decided to use a little more elbow grease (I was scared to chip the plastic) and the other side went in too. The hardest part was trying to align all the screws in the holes so that they all matched up.
The cover is still not perfectly flush but I assume some gap is unavoidable.
Out of curiosity, what are the meanings of the "H. HOLD" and "V. HOLD" dials on the back? And is the H. HOLD dial supposed to not be able to move?
Also, what do the "HEIGHT" and "AGC" dials do?
I like to know what everything does!
|