Quote:
Originally Posted by Dreamsbeard
Pincusion would be for the pull in right?
|
Pin problems give an hour glass shape. Adjust it to far & it
takes a barrel shape.
Pin control is VR504. The cap that goes is C521 its off one end
of the control. The manual says its either a 1mfd or 3.3mfd.
There may also be a 1mfd tacked in in parralell with it
prob under it. Use whatever it used.
Focus is a tap marked F1, F2, F3. probable wont see any difference.
Color problem check for bad solder on CRT board & dirty
controls. Common conections are at socket itself & the 3 output
transistors. That will keep you busy for now.
73 Zeno
