|
Ok, here is where I am at. I decided to take the full size CRT out of the cabinet and try it. With the width sleeve in, I'm getting too much width on the right side and not enough on the left. Centering rings won't compensate for this. See pic.
Horizontal is still messed up. First off, it's not a pot. It's a coil with a top slug for find adjustment and a bottom slug for course adjustment. I'm going to check with Moyers tomorrow to see if they have a replacement. All my Sams has is the original Silvertone # 10-121-1.
Dave, I had replaced R36 earlier, but the other night decided to experiment and tried a 6800 ohm, 10K, and 15K. All that happened was I had to turn the hold to a different frequency, and it was still unstable.
I checked all the voltages on the 6CG7, and they are normal. I then moved back to the sync. V5 Sync Sep 6BH8 SB 7.5V on pin 3, and I have around 25.
Also on the Sync Amp 5U8, Pin 8 SB 9.5, and I have around 25V also.
I have rebuilt K1, K3, & K5. K2 seems to be tied into these problem areas. Perhaps I should rebuild K2 next.
|