|
I measured from vert pot to plate and the resistor that is next to the tube is a 2.7 meg that is off quite a bit, reading around 3.2 meg. the next two along the line before plate is pretty much dead on spec and are farther away from the tube.. I'm also measuring them in circuit.. Not sure if the readings are correct.. I was told that some resistors you can measure while still in circuit.. Rather not pull anything off this board unless needed too..
__________________
Looking for an all tube or hybrid color TV set from the late 1960s, early 1970s that's in a steal cabinet..
Last edited by tvcollector; 01-13-2015 at 11:40 PM.
|