[Username1]

Each tie point on the fly has a clearly marked indicator as to what it is...?
Anyone have one of these on the bench and can put up a picture of it for
reference...? Does the Sams have resistance checks between each pin set
to check against a resistance number...?

Is there a way to check to be sure these three points are guarantied
wired correctly.....?

For coils:
They usually mark it on the schematic, for default I go to tube view, clockwise
looking from above and one pin is usually got an identifier, it's pin 1.
Resistance checks are a good backup for things that are not clear.
Even if you have to go and test another coil somewhere else in the set...

Thordason usually packs a install note with their transformers, and in some
cases Sam's notes replacement part oddities, like a tie point not internal
on a replacement fly.

Whatever you do, don't swap any wires until we have a really really reasonable
bit of evidence that something may be wrong with the way it's in there......
If this thing explodes I want it to be because we decided to dynamite it
on purpose from a safe distance and film it for youtube....

Anyone got picts of focus coil & flyback wiring we can check out as reference...?
Any replacement notes, etc. Ideas, dynamite, demo caps remote det. ???
.