|
EUREKA!! It works!
I took advice from you guys and added a bit of real solder to the connections on the IC's before wicking it off. That worked just fine.
The new IC's are working as they should.
See some bad pictures below. The screen image is much better than what you are seeing here.
While I was under there, I resoldered the flyback, the horizontal driver transformer, and the horizontal output transistor.
I also touched up the soldering on the CRT board.
This set has seen very light use.
__________________
Bruce
Last edited by holmesuser01; 01-18-2015 at 08:18 AM.
|