|
ok L14 measures 11.6 and 6.6 ohms so thats ok. the crt bias measures 6.20 k from terminal end to end and the wiper, the ohms are smooth. what is an acceptable ohms for the bias pot at full counter. all resistors around the service switch test perfect. i even took the pot apart to see if any burn marks or anything that dont look right, it looked new. i am curious as to which wire and where it goes is the actual one that triggers or determines the hv regulation because if the regulator is good now then if there is anything else further up the line in the circuit somewhere that maybe off a bit because this is the biggest improvement in this set since i have it. so its just about there. 6gm6 i changed even though it tests good just the heater lit very fast as opposed to another new one i have so i changed it to avoid anything later with that tube if the heater was stressed in any way.
|