Quote:
Originally Posted by John Marinello
Has this set been restored? If not, then you should be thinking full restoration, and not of repairing the set. If you insist on operating the set as-is, keep close
tabs on the four filter cans. If any start getting hot, you had better shut it down in a hurry. Also, there is a picture control switch in the pencil box. You
need to have it in full circle mode before you can make height + linearity adjustments. Looks more like the AGC is set too high. Do you need a channel knob for it?
|
Someone prior to me owning it recapped all the paper caps, and only 2 single ecaps. I just recapped the remaining 4 cans, checked a few mica's, replaced a out of spec bumblebee cap on the width control, and found and replaced a bunch of out of spec resistors in the horz and vertical section.
Yes I have it set to full circle. I have the knobs for it in storage, just did not find them yet.
Also all the tubes checked out ok.