|
maybe i dont have a brightness problem i say this because if i were able to set up the R G B drives without having to raise up the bias to just about max then it may be bright enough because these drives do determine brightness to a degree and with the bias down or even half way up i dont get anything, cant see the R G B lines to setup the right way. so maybe there is an issue with these drives because the green is the brightest blue is second and red is the last so if i were able to set the drives higher then i think this would cure the problem but i already checked every resistor related to those drives along with all the power supply resistors, all the high wattage resistors and a few carbon resistors. the voltage at the HOT i think is alittle high although i dont have a spec of what it should be its at around 175 volts if i remember correctly but i did write it down. if i compare to other sets it seems high. most times i found that green always comes up stronger but with this set i dont see it until the bias is just about maxed. so maybe something related to those drives.
|