Quote:
Originally Posted by Username1
Hi !
Not what I was getting at..... On the first page of this thread a picture is posted of the
3 convergence coils held on the neck of the picture tube with the help of a zip tie.
I was just wondering if this method changes the orientation of the coil, with respect
to the electron gun, and it is either tilted towards the yoke a little, or away from it
and results in the downturning of the blue line in the cross pattern on the screen
in a posted picture on this page of this thread....
Left most picture post #64.
.
|
Take a look at post #39. I have removed the tie-strap and am experimenting with some springs to try to space the pole pieces closer to correct. The green plastic is cracked and is allowing that pole piece to tilt some. More work will be required to position them properly. I would try to find a Zenith replacement part but this set has already had this plastic piece replaced before and it has failed twice. Also, I have only done a very quick convergence on the set, as I have been moving the chassis between the work bench and the cabinet as I test and fix problems. So yeah, its nowhere near done yet. I just wanted to show the results of the alignment, the delay line terminator repair, and the color kludge. At least it now has a good start on a watchable picture.
Dave